ওয়ানলং টাইমস
Stone cutting machine, also known as stone cutting machine, is a multi-knife and multi-stage stone cutting machine composed of cutting knife group, stone conveying platform, positioning guide plate, frame, ইত্যাদি.
Stone cutting machine installation method
1. First place two parallel tracks on the ground, the width of which is the same as the width of the cutting frame walking wheel.
2. Place the frame on the parallel tracks and move it back and forth so that the tracks are completely consistent and move freely.
3. Place the main machine of the stone cutting machine on the frame. The four rollers on the main machine must be completely consistent with the channel steel on the frame. The movement direction of the main machine after placement is 90 degrees cross with the movement direction of the frame, and each can move freely.
4. Install the power supply so that the motor is firmly connected to the main machine through the motor tripod, and the direction of the motor axis is horizontally and vertically crossed with the direction of the main machine.
5. Install the belt.
6. Install the protective cover.
7. Start the motor and check that the rotation direction of the saw blade shaft is consistent with the direction indicated by the arrow of the protective cover.
8. Install the saw blade. Connect the water pipe.
Stone cutting machines are widely used because of their high processing efficiency, low production cost and easy use. In order to be able to play these functions normally, the correct installation method must be guaranteed. সুতরাং, mastering the installation method of stone cutting machines is a prerequisite for normal operation.
Stone cutting machine operating procedures
Before work
1. Wear work clothes and goggles. Female workers with long hair should put their hair up and wear work hats.
2. Check the power switch, saw blade tightness, saw blade guard or safety baffle in detail. When operating at night, the operating table must be stable and well lit.
3. Turn on the main switch and test a few turns without load. Only start the machine after confirming safety.
When working
1. It is strictly forbidden to operate with gloves. If dust is generated during operation, a mask or mask should be worn.
2. Do not try to cut small workpieces that are not clamped.
3. This cutting machine is only allowed to cut profiles.
4. Do not perform strong sawing operations. The motor should reach full speed before cutting.
5. Do not allow anyone to stand behind the saw.
6. Do not lean over or get close to the saw. Do not release any hands or arms from the saw or workpiece when the saw blade is not stopped.
7. Do not operate when the protective cover is not in place, and do not put your hands within 15 cm of the saw blade.
8. Before repairing or replacing accessories, the power must be turned off and the saw blade must stop completely.
9. If any abnormal sound is found, the machine should be stopped and checked immediately.
End of work
1. Turn off the main power supply.
2. Clean and organize the workbench and site.